RF Test System Controllers |
|
SC1000
|
Controller designed for multi-ampilifier/multi-load applications where reverse power measurement is not neccessary |
Login or Register
|
|
SC1000M1
|
Controller designed for multi-amplifier/multi-load applications with forward and reverse power measurement and emissions feedback |
Login or Register
|
|
SC1000M2
|
Controller accommodates forward power measurements and higher power/high frequency amplifier and load combinations where switching and cable losses need to be minimized |
Login or Register
|
|
SC1000M3
|
Controller accommodates forward and reverse power measurement and higher power/higher frequency amplifier and load combinations where switching and cable losses need to be minimized (Other variation of controllers without switches or with lower priced switches are available - Contact factory) |
Login or Register
|
|
SC1000M4
|
Controller accomodates forward and reverse power measurement and higher power/higher frequency (up to 40 GHz) amplifier and load combinations where switching and cable losses need to be minimized. |
Login or Register
|
|
|
|
| |
| The Models SC1000, M1, M2 and M3 are rack mountable(48.3W x 13.34H x 45.75D cm) or stand alone, RF System controllers designed to facilitate the concurrent use of up to three signal generators, four power amplifiers, four directional couplers and four different RF loads for broadband RF testing DC-40 GHz. RS-232, IEEE-488 and/or manual control. In combination with our SW1006 EMC test software they form the Brainlink? System. |
For a list of discounted products, visit the AR Bargain Corner.
